The standard table size is 7”x7”x5/8” thick and is made from very durable HDPE. All 1” post models use a heavy-duty 3.5” steel faceplate for the interface and mount directly into the banjo with the supplied 1” post. The 5/8” post models use a 2.75” diameter steel floor flange and mount directly into your lathe’s banjo also.
The standard table is 7”x7”x5/8” thick. We offer larger sizes of the same thickness at an additional charge.
What's On Sale?


The Type 2 Longworth Chuck is different in 3 major areas:
i) The disks are ½” HDPE (high density polyethylene) and there is no UHMU layer needed.
ii) The Type 2 is equipped with a threaded faceplate and threads directly onto the lathe spindle.
iii) An OPTIONAL accessory is a set of Doughnut rings for use with the Type 2 Longworth Style Chuck only. The Type 2 chuck may be used in the traditional Longworth scrolling mode or as a traditional Doughnut Chuck with doughnut rings.

Using a steady rest eliminated most all vibration and chatter on thin spindles. When the wall on a bowl gets thin it tends to vibrate and rough cuts are the result. A steady can eliminate that vibration and give a much better finish cut. With taller vessels further away from the chuck, the more leverage works against you and the more likely you are to pull the vessel off-center

Made from 5/8 inch thick High-Density Polyethylene and supplied with a factory-mounted heavy-duty faceplate lathe ready, Ron Brown’s Best Lathe Mounted Disk Sanding attachment is stable and rigid. It is the ideal way to quickly sand your segmented rings dead flat. As with any disk sander, there are many more uses as well.These 12 inch Pressure Sensitive Adhesive 80 Grit discs consist of Aluminum Oxide abrasive material that is bonded to a x-weight cloth backing. The resin bond is a strong bonding agent that keeps the Aluminum Oxide grains on the cloth backing while providing an element of heat and pressure resistance, extending the useful life of the disc.The aluminum oxide grains offer a fast cut rate while still remaining economically priced.

These glue presses are perfect for Bowls From A Board as well as traditional Segmented Ring Projects. With clamps at all four corners and flat rigid clamping cauls, even pressure is applied across the surface of each ring for perfect glue joints. HDPE is known for its non-stick ability as any glue squeeze-out will easily just flake off with little effort. This material is resistant to warping, chemicals, and temperature changes. This unit should last for a lifetime of use when used according to instructions and stored properly. We have sizes compatible with most segmented projects: Six Configurations: 10” x 10” – Diameter – Height 10” x 20” – Diameter – Height 14” x 10” – Diameter – Height 14” x 20” – Diameter – Height 16" x 10" – Diameter – Height 16" x 20" – Diameter – Height Each Press comes with a 5/8” thick HDPE base and top. It has 4 bolts, 4 Five-Star Knobs, and associated nuts and washers. If you have any questions or special requests, don't hesitate to contact us at (770) 962-3821.
Featured
Upgrade for Longworth Type 2 - 16 Inch
Gain additional versatility and holding security to your Longworth Type 2 Basic chuck. Your projects..
$169.99
Upgrade for Longworth Type 2 - 12 Inch
Gain additional versatility and holding security to your Longworth Type 2 Basic chuck. Your projects..
$149.99